It is well known that the van filter 3 has reached a high water quality treatment, so the device can easily treat all kinds of wastewater.Usually, filter feed pumps are unacceptable in front of various wastewater.After all, it was a disaster for the wastewater.Whenever a high amount of water.After all, accept all kinds of dirt and have a very proud feeling to see the pure water from the filter cloth.
In many cases, it is impossible to avoid evaporation of water when the van filter 3 encounters high temperatures during filtration.The evaporation of water will somewhat reduce the actual work efficiency of the equipment.After all, if only the results are observed, the treated liquid decreases slightly with evaporation, but this is also a normal phenomenon, which is inevitable in actual production.
If we can better understand the weather changes when the press works, it can extend the service life of the device.But, many times we are always influenced by various reasons.This important factor is ignored, which requires particular attention in future production.The hydraulic system of the press filter is important to the whole system.The selection of good hydraulic oil has a great influence on the plate frame filter.Hydraulic oil can provide a powerful pressure for the press.If you want the press to work properly, you need strong pressure.When selecting hydraulic oil, consider various factors and select a neutral pressure oil resistant to wear and pressure.
What is the amount of hydraulic oil?
The hydraulic system of the van filter has a hydraulic station to pump and store oil.The storage space of the hydraulic station is also very limited, so you need to add appropriate hydraulic oil to the station.Under normal conditions, the amount can be about 85% as the oil temperature increases and excess oil will directly affect the normal operation of the hydraulic station.And.The amount of oil in hydraulic stations shall not be less than 40% because too little oil will affect the internal pump.Therefore, it is necessary to regularly inspect and maintain the hydraulic stations in daily life.
When the control system fails, or the hydraulic system can not control, or the control system cannot detect the state of the hydraulic system, the pressure filter naturally can not work, even if almost impossible to operate, so it is necessary to stop the equipment work in time.
The reason why the van filter 3 stops working may be that the flow path in the device is blocked.When some flow channels in the filter are blocked, this will prevent the filtrate from entering or being excluded from the device, so the filter will suddenly stop running and stop flowing out of the drain.The liquid is coming soon.In this blockage, even if the filter liquid is in contact with the filter cloth, the filter separation does not occur because the pressure difference is not formed, so the pressure filter stops working naturally.
