In the normal operation of diaphragm presses, we often find that diaphragm filters have a thermal appearance.This heat will have a certain impact on the application of the press, so how can we make this overheating?The diaphragm filter is overheated for two reasons: one is a hydraulic system, and the other is a pressure filter.The hydraulic system of the press filter is closely related to the temperature.It can control the hydraulic system through the heat discharge device of the equipment, allowing the press filter to function normally.Excessive temperature of the hydraulic station is particularly important because it will affect the hydraulic system and the system will not work properly.The plates are made of polypropylene materials to avoid overheat treatment, slow temperature rise, reduce differentiation of the plates and yttrium oxide, and application cycles of the plates.Reduce filter plate damage, improve productivity, and achieve higher profitability.
If the filter is overheated, it will not only have a great impact on the operation of the staff, but also have a certain impact on the filter liquid during the operation process, resulting in the filter fluid change, thus affecting the separation.Effects, so you should watch for the operation.Overoverheating of the filter.
1.If the diaphragm filter bearing is found damaged, please replace it in time.Very strict standards are required for installing the new bearings.Be careful not to be free.
2.Prevent strong impact, scratches, indentation and cracking.
3.In the process of using diaphragm filter, pay attention to regular rust prevention bearing, do not dirty water stains.Clean the enclosure, apply lubricant and maintain.
An error in the filter control system may cause the filter to stop working.As is all known that when the press filter works, a control system is required to control the hydraulic system and the range of expansion and contraction in order that controlling the power generated by the hydraulic system to the filter board and the received power filter board can be transmitted to the filter.。。On the liquid, the filtrate is directly exposed to the filter cloth through pressure, so the control system of the press directly affects the filter filtration.
When the control system fails, or the hydraulic system can not control, or the control system cannot detect the state of the hydraulic system, the pressure filter naturally can not work, even if almost impossible to operate, so it is necessary to stop the equipment in time.。Work.
The reason the filter stops working may be that the flow path is blocked in the device.When some flow channels in the filter are blocked, this will prevent the filtrate from entering or being excluded from the device, so the filter will suddenly stop running and stop flowing out of the drain.The liquid is coming soon.In this blockage, even if the filter liquid is in contact with the filter cloth, the filter separation does not occur because the pressure difference is not formed, so the pressure filter stops working naturally.
